|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
|
Thread Tools | Display Modes |
|
#11
09-25-2024, 09:39 PM
|
||||
|
||||
Re: 1/16 Scale FrankenDiff
Getting close! Almost every FDM printer I've used will make IDs too small. Normally I drill them out. Even the industrial printer's SLA parts I've ordered are a bit of a wildcard in term of tolerance.
When bearing pockets are too big, I'll do a single wrap of tape on the outside before installation. Tape choice based on how far out the pocket it maybe scotch, maybe painters tape. I'm also not above a drop of CA glue either. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode