~1:12 Miller Century M100 Rotator wrecker

[dremu]

A selection of accessories for the discerning recovery crane operator.



Outrigger pads, printed in TPU,



But also various attachments for the underlift, including the center one (red) for kingpin attach, narrow and wide straps, various shackles, bungees, slings, fire extinguisher, wheel whocks, coupla pieces of drayage (okay, lengths of square dowel ) and the short spreader bar. There's also a long one, to prevent squishing irregular loads when rigged. The spread bars are metal tube with printed ends and so far held up to the load of the conex. Wouldn't trust a printed round that long though, plus metal is cheap at the hardware store and looks better.

By the by, I greatly enjoy Pepe's Towing YouTube channel. Josh can explain the spreader bar far better than me.

Also printed up extension ladders in sizes



Because the stepladder I made was beautiful, but didn't scale down for squat.



Also got to use some of the many, many cones I made for the HEMTT.



I think I made like eight or ten in each of a half dozen colors, got a bit happy. But I like cones. Handy around the house even: