|
|
|||||||
| General Discussion A place to post off topic discussions. |
|
|
Thread Tools | Display Modes |
|
#6
05-01-2011, 01:41 PM
|
||||
|
||||
Re: M4 Angle Joint - Anyone know where I can find some of these?
The smallest rod end I could find, with a metric stud in it, was 5mm. Perhaps you could locate a metal rod end, with a swivel ball, and a through hole, so that you could just run a cap screw through it? McMaster has more english sizes then metric sizes for both types of rod ends.
http://www.mcmaster.com/#ball-joints/=c48mp3
__________________
Nathan 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode