|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#11
11-06-2012, 08:18 PM
|
||||
|
||||
Re: geared motor
Here are the pics of the foam that I bought. It cost me $15 for this piece so it's not that expensive. I used a bandsaw to cut the outside and a razor blade for the inside.
I think Joe is right about the rpm of the gear motor you need. Personally I wouldn't buy anything that was over 200rpm or it will be pretty fast. My skidder for example has 152rpm motors with a 2.6-1 axle and 7 3/4" tall tires and the speed it quite good. Reg 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode