Wheelbase measurements

[doodlebug]

Originally Posted by scalelover

Sorry if my description was a bit unclear. When I was describing the axles I meant both rear axles --front tandem and rear tandem. I knew the front measurement was from center o the steering axle. But yes this does help very much, I just was not sure at which point I should measure in the rear. So knowing that its at the center point of the suspension I can finally start setting it up.

--Dan

Depending on your local bridge formula ( that legal >>>>) tandem axle's are spaced 52" to 72" spread. Centerline to centerline.
On twin steer tandem axle's, 54" is minimum, and I've seen spread's of 120"+
http://www.raydanmfg.com/?page=products&ProductId=5 see this page for more info. The gallery page show's all kind's of tandem steer spread's. http://www.raydanmfg.com/?page=media&section=gallery Or you can search thru Hank's Truck Picture's http://www.hankstruckpictures.com/ma..._emotions.html


Hope this help's, Neil.