Receiver issues - RC Truck and Construction

		RC Truck and Construction > RC Truck's General Discussion. > General Discussion
Receiver issues

General Discussion A place to post off topic discussions.

Thread Tools

Display Modes

12-14-2012, 04:32 AM

FlyingBeagle FlyingBeagle is offline

Green Horn

Join Date: Dec 2011

Location: Lexington, KY

Posts: 167

Re: Receiver issues

This is just a total guess, but is it possible that the sub trims on the channel are set too low. I have run into that before with an optical kill for an ignition for a gas airplane engine. It would not recognize the signal because even with the switch on, the signal strength was still below the threshold for activiating the kill switch.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 08:10 AM.