How to make hydraulic valve? - RC Truck and Construction

		RC Truck and Construction > RC Truck's Ag and Industrial Equipment and Buildings > Construction Equipment > Construction Equipment Tech
How to make hydraulic valve?

Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip

Thread Tools

Display Modes

#13

01-01-2013, 01:45 PM

ihbuilder

Fabrication and design , super moderator

Join Date: Aug 2010

Location: in a cage in Auburn,PA

Posts: 3,557

Re: How to make hydraulic valve?

JW : steel or iron next to brass would be the best choice for your manifold . Aluminum does not wear well .

Madda : O-rings work well for the seals as you should only have to seal the shaft of the rotor and the rotor cap . between the rotor and the valve block , you should have a lapped fit .

__________________
RIP FreddyGearDrive 2-12-59/12-19-11

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 06:37 AM.