Day Cab Work Truck by Izzy

[Izzy]

A whole lot more movement - and it seems like the drive shaft (i have the rc4wd shorty shaft) doesn't seem to telescope at all......

the diffs did seems to have a little bit of gear mesh issue - didn't tkae em apart to investigate - I've had some stock axels that just seem to have a bad spot or so. figured I'd give em some time to run in...... for my driving time that's about 3 or 4 years though....

There's no provision for shocks - so the axels lift plenty high - just like std tamiya (if you use nylon nuts on the center spring keeper plate) But the twisting is phenominal - jsut as easy to lift just one wheel as it is to lift the whole axel. goo figure for a three point suspension.....

[CustomRCmodels]

Originally Posted by Izzy

the diffs did seems to have a little bit of gear mesh issue - didn't tkae em apart to investigate - .

Chris ,
I do have the same axles ,
just loosen up the diff covers ,
then pay close attention to which screw of the diff-covers is right in the center of the axle , loosen that screw , use a short one or add a washer .