|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#5
10-20-2010, 03:09 PM
|
|||
|
|||
Re: Servo help
Joe-I am assuming that you are talking about the servo on the pump. Is there metal to metal on the linkage that would cause interference? Also if the linkage is not adjusted correctly and causing the servo to be in a bind can cause the servo to react violently. Have you tried removing the linkage from the servo and then turn it on and see if it still does that. Could also be a servo problem but not to likely if it is almost new.
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode