|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
|
|
Thread Tools | Display Modes |
|
#11
09-10-2013, 04:35 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
Jim,
You could always use the control board out of a cheap but powerful servo to use as a speed controller with smooth forward to reverse action. You would have to add resisters to the servo board to give you "center" just like converting one for continuous rotation. i am sure the control board in this servo could feed up to 2 amps to a motor and i doubt you would even draw 2 amps. http://www.hobbyking.com/hobbyking/s...Fc07OgodjU8Alg
__________________
Scott "No load is too Small" 
|
| Currently Active Users Viewing This Thread: 11 (0 members and 11 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode