Tonka Conversion

RCP57 · #1 10-03-2013, 06:07 PM

If you look at the pictures closely it appears that the axles are already drilled for cross pins.

rsd53 · #2 10-03-2013, 06:53 PM

Quote:

Originally Posted by RCP57

If you look at the pictures closely it appears that the axles are already drilled for cross pins.

You know, I believe you're correct! Thanks for pointing that out to me.

RCP57 · #3 10-03-2013, 07:14 PM

No problem!

SmallHaul · #4 10-03-2013, 08:28 PM

This is how i attached the wheels on my first tonka conversion.

rsd53 · #5 10-03-2013, 08:42 PM

I saw this in your build photos. It looks like there is a brass bushing inside the tire, that is glued in? I looked at the axle you recommended, but need to know the size of the nut to put on the first tire and the next for the outer. also, I am waiting for a response as to size of the pin.

SmallHaul · #6 10-04-2013, 09:15 AM

Yes, there is a brass sleeve glued into the plastic wheel to provide a hard/solid surface for the axle to sit in.

rsd53 · #7 10-04-2013, 09:36 AM

Can you provide me with any information on the fasteners you used?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)