|
Construction News New kits & accessories offered in the world wide marketplace |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Re: Magom HRC metal 1/14 track loader
Quote:
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#2
|
|||
|
|||
Re: Magom HRC metal 1/14 track loader
It's the HR-7 / 4003. Magom does not use a reduction transmission, to keep cost down, installed a oversized motor in order to reduce the rpm. But I personally think it runs higher at full speed than the recommended 3-4000 max rpm for the pump. Too small tank (50-100 ml, vs Premacon 500 ml), no good cooling of the oil, which then more quickly gets hot and start foaming. Magom got much nice suff now, as the tracked loader, but they still got some way to go concerning their pumps, IMO.
Last edited by Rimrock; 02-10-2016 at 04:23 PM. |
#3
|
||||
|
||||
Re: Magom HRC metal 1/14 track loader
Quote:
I started with that pump in my Fumotec 490, it was like operating a pneumatic system, too fast - kinda springy movements. I put that pump in my JD850 & with it's much larger cyl bores, it's perfect speed, especially on the twin 18's lifting the boom. I doubt Magom pays any attention to this forum, so my words are meaningless...
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|