|
General Discussion A place to post off topic discussions. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Dumb Question About Double Square Headlights
I have a set of the PMD Double Square Headlights, do you just epoxy the turn signal lenses on the end? Doesn't seem right to me but don't see another way. Also I assume the smooth side goes to the outside but this would mean the epoxy is really only holding on the high spots of the jeweled side. Nothing about this seems right to me, need help.
|
#2
|
||||
|
||||
Re: Dumb Question About Double Square Headlights
Hey Craig..I put the smooth side to the light with ca glue..It seems to hold up well..I haven't any problems with them..better holding area..i didnt like the gap it made..
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. One Bus Stop Short Of The Short Bus... |
#3
|
||||
|
||||
Re: Dumb Question About Double Square Headlights
Thanks John, I knew there were many of you guys that had been down this road.
|
#4
|
||||
|
||||
Re: Dumb Question About Double Square Headlights
yup...its not bad..I just didnt like the way they sat..unless you want to try to sand the smooth
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. One Bus Stop Short Of The Short Bus... |
#5
|
||||
|
||||
Re: Dumb Question About Double Square Headlights
Unless you get some thick transparent plastic like from a spare cd case (smooth part) cut to shape and glue that on and then paint it with some tamiya clear orange? Just an idea.
__________________
Nick My Peterbilt build thread: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#6
|
||||
|
||||
Re: Dumb Question About Double Square Headlights
Craig I CA glued the lenses with the points in. I have done this on my last 3 builds with no problems.
Brian |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|