|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Re: 1/16 Bucyrus-Monighan Walking Dragline
wow, so nice!!!! Incredable details.
Dan |
#2
|
|||
|
|||
Re: 1/16 Bucyrus-Monighan Walking Dragline
That's looking great! I like the catenary in the hoist cables. It's little things like that that make it look even more authentic.
|
#3
|
||||
|
||||
Re: 1/16 Bucyrus-Monighan Walking Dragline
It looks awesome with all the rigging. It makes it look massive even though it is a model.
__________________
Scott "No load is too Small" |
#4
|
||||
|
||||
Re: 1/16 Bucyrus-Monighan Walking Dragline
I finally got the boom hoist attached to the machinery deck and was able to boom up under power for the first time.
The motor I used had no problem raising it. We timed it today and it takes about 15minutes to get up to 25 degrees. Tiny 0-80 set screws I wish I would have had a sharper endmill when I made the hoist,My new camera picks up all the bad details A full drum of cable. While getting the drag ready for Sunday I decided to drill and tap the drag jaw clutch bolts. When I'm pulling in hard it would slip because it was only pressed in. Now we'll have to watch we don't pull too hard digging because the only weak point is the motor coupling. Or it may just drag the whole machine into the pit Complete load unit. And walking pinion. Tapered lock bushing I made to lock the gear to the shaft. Exploded view Bearings Last edited by 9W Monighan; 05-07-2011 at 11:05 PM. |
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
|
|