Classy Shak

[bigdogrod]

simply amazing build..

[Dreamweaver]

Originally Posted by CrimsonCorsair

I too was looking to put the steering servo inside my CAT motor. I would be interested in what work you were planning on having Lynn do. I was planning on dropping the oil pan and opening up the hole in the bottom of the motor enough to slip the servo (HiTech 645) inside. I was hoping to replace the oil pan, however the servo will not fit far enough into the motor to allow this. Is this the work you will be having Lynn do for you? You would need to remove the bases where the two motors are joined by screws and then find another method to attach the motor back together again. Even doing this I am not sure the servo will fit far enough into the motor to re-attach the oil pan. I would be very interested in your plans - especially if you have solved this dilemma. Who knows, maybe Lynn will have two motors to modify

Well I sure would like to tell ya but as of right now we have not figured it out completely. From what I can see when I look in the motor I have found servos that will work. Lynn will be removing the tubes that hold the screw for the oil pan and then I will mount the pan by a screw in both the front and rear covers.. Other than that Lynn has to get it in his hands first and then we will discuss the best way to go about the install. I will certainly let ya in on the how to when we get it done. Remember also that I have turned the pan around on my motor so the servo shaft will be going through the hole on the shallow part of the pan.

Originally Posted by bigdogrod

simply amazing build..

Thank you Sir...



The suspense is killing me. Steve sent my air cleaners on Monday and the pony express... I mean USPS has not got it here yet...

~Mike~