|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
10-26-2010, 08:31 PM
|
|||
|
|||
Re: centering
i was working some 3/4 in cold roll making top rollers i was drilling a 1/4 inch hole through the center has to be in the steel i trued up another peice and then used the centering bit all is good i drilled my 1/4 inch hole 2 1/2 inches into the cold roll no problems tonight all is well in clyde land lol thank you all for the help .........needless to say i am no machinest but i am starting to make some decent parts finally lol
__________________
I built this thing and have it working now what do I do with it? 
|
|
#2
10-26-2010, 09:27 PM
|
||||
|
||||
|
Re: centering
Sounds like your on your way. Only other thing is, if the drill bit isn't ground exactly true on both lips it will walk over. Best to drill under then bore to size.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
