|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
08-11-2016, 05:22 PM
|
|||
|
|||
1/32 komatsu excavator
Hey lads and ladies I'm looking to build a 1/32 komatsu excavator just looking for help. I will start putting up picks once I start thanks everyone
|
|
#2
08-21-2016, 06:29 PM
|
|||
|
|||
|
Re: 1/32 komatsu excavator
Hey just want to get a bit of feed back on cold weld. I want to do the screw mechanisms but I'm using 3 mm brass tube and I don't have the tools to weld it will cold weld do. Or will I have to tig weld ?
|
|
#3
08-21-2016, 08:40 PM
|
||||
|
||||
|
Re: 1/32 komatsu excavator
You'll want to solder brass, with a very hot soldering iron or small propane torch.
|
|
#4
08-22-2016, 02:58 PM
|
||||
|
||||
|
Re: 1/32 komatsu excavator
You can find some input at You Tube. RC Tractor Gay show the building in some vid's.
https://www.youtube.com/watch?v=725lNnHERlc https://www.youtube.com/watch?v=TndzVRzNQts https://www.youtube.com/watch?v=pEQ4AX7TAvk https://www.youtube.com/watch?v=MjEHbxDEpxE https://www.youtube.com/watch?v=ioq2dujxgiI https://www.youtube.com/watch?v=GtE6t1oODbI https://www.youtube.com/watch?v=LBrBJFAicWE https://www.youtube.com/watch?v=NTFBF358v94 https://www.youtube.com/watch?v=1eSBqqXumno Manfred
|
|
#5
08-22-2016, 05:37 PM
|
|||
|
|||
|
Re: 1/32 komatsu excavator
Hey thanks for the videos I have seen them b4
When I use the torch do I need flux or does the solder have enough thanks for ur help already
|
|
#6
08-22-2016, 07:09 PM
|
||||
|
||||
|
Re: 1/32 komatsu excavator
I've always used a flux, it flows the solder, makes for a better joint.
|
|
#7
08-23-2016, 05:03 PM
|
|||
|
|||
|
Re: 1/32 komatsu excavator
hey i didnt get any flux yet put i did make a good solder/weld today so im one step closer
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
