|
Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
Thread Tools | Display Modes |
#3
|
||||
|
||||
Re: Sherline /Taig /Maxnc or bench top router ???
Thankyou Nathan..Another question ..How important is it to have a closed loop over an open loop when it comes to say machining a pump...Is the open loop capable of doing this task if the backlash is very minimal
Last edited by tracksntreadslou; 01-13-2013 at 09:12 PM. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|