cnc ?

[fhhhstix]

Originally Posted by Operator

R-8 tooling is all you need, and is everywhere cheap. Make a power drawbar for about $50 out of a small air cyl, and a HF butterfly air wrench. This is about as quick as it gets to changing tooling. Unless your running a production shop with employee's, save your dough for extra endmills, you will need them though your cnc programming learning.

I was at my local machine shop yesterday and watched him work for a little while and he has the butterfly wrench set up on his mills and it is a real slick way of changing tooling.

Travis

[Operator]

Originally Posted by fhhhstix

I was at my local machine shop yesterday and watched him work for a little while and he has the butterfly wrench set up on his mills and it is a real slick way of changing tooling.

Travis

Slicker than snot, for cheap


http://home.insightbb.com/~joevicar3/cheap_drawbar.htm