[avel]

Espeefan, you were partially right. It did cause problems leaving the internal stop sleeve out. Now I can curl the bucket back more but this causes problems if I don't uncurl it a little when lowering the bucket. The lift pistons fight the curl piston when lowering the bucket with it curled back. I blew a tube and ballooned another one in two spots.

With all the hydraulic lines connected the pressure jumped to 22bar at times. I am going to lower it a little and try to operate it the way it is. Normally when operating and lifting a bucket of dirt I always dump it and then lower the bucket so I don't think this would be an issue in normal operation. I am uploading a video right now, doesn't explain things that well, but at least you can see what is happening.