Quote:
Originally Posted by Jakyat
HELP!!! I am building an oilfield winch truck. I have designed a winch that runs off of 2 high torque continuous rotation servos. I am very satisfied with the pulling power of the winch, however, when I let off on the control, the servos will not hold the load. Maybe there is nothing I can do about this problem.
The servos are Hi-tec digital programmable, and I am running the unit with the spectrum 18 ch radio. I know there are lots of allowable adjustments that can be made through the radio, but I don't know where to start. I also have a hi-tec servo programmer, but I don't think that I can make this adjustment through the programmer.
Can anyone help me out with this?
|
The servo cannot hold center because it does not have a center point like a regular servo. It does not have a pot in it for position so it has no idea of what center is. For a winch to work right you need a mechanical advantage and you can achieve this in a couple ways.
1 a mechanical brake.
2 gear reduction such as a worm gear set up.
3 A mounted block and pulley set up so the direct pull is on the block and pulleys and not directly on the winch. This will also increase your pulling power as well.