After working Thursday, & then finding out we're working Friday NIGHT, I stayed up all night to get my self acquainted with night shift AGAIN! I had a LOT of time to work on the littel dozer.
I found a PROBLEM with where I mounted the blade control rod. I SHOULD have ended the bolt between the 2 side of the blade arm, & NOT ran completly through it.
20170817_225951 by
Anthony Kalnoski, on Flickr
It SHOULD have ended where the knife blade is, & has since been re-located.
20170817_225345 by
Anthony Kalnoski, on Flickr
I cemented the blade pivots where the knife blade is, to prevent it from moving while working
20170817_225400 by
Anthony Kalnoski, on Flickr
Each drive sprocket got TEN screws placed into them between every OTHER tooth.
20170817_205810 by
Anthony Kalnoski, on Flickr
NOTE:
DON'T do like I did! Before I reinstalled EVERYTHING onto the tracks, I adjusted the slack in the track by lengthening the distance the screws stuck out form the sprocket. Once I re-assembled the track guides, the tracks were too tight.