So, still in a slump.
But I have gotten a little bit of work done in the past week or so.
This is a solid beam non-steering lift axle.
[img]
[/img]
It was a long project to get this to print right, then to figure out a mounting system for it, then to realize that I was not going to use it on the T800W frame, it is too short!
Still, I am slowly making some progress on the T800W build. Although, I have recently come across the idea of using all Tamiya parts on my differentials, so it is done right, as the plastic gears are prone to binding up.
[img]
[/img]
Feel free to leave a comment!
Jon in Vt.
The Northern Rednecker