Quote:
Originally Posted by ddmckee54
How much of the disc will be printed? At first I assumed that all the green would be printed; but then I realized that those were probably just the painted parts on the full-sized disc.
Any possibility of another shot of the disc from a different angle? I'd like to see how your lift linkage works. I've got a Quad-trac that I've been planning on converting to RC and building a 3D printed pan scraper to pull. I'm not above shamelessly copying a good idea when I see one.
Don
|
Don,
Here is the section showing the lift linkage. I'm using ~1" linear actuators. The linkage should help the implement lift somewhat level.
