Quote:
Originally Posted by cosworth34677
so this is all steel? i want to try to make one of these, but i only can cut aluminum on the router table at work. can i use plastic on any parts? and why not aluminum? thanx for the thread guys lot of good info !!
|
The top of the valve in the last pic is aluminum but the bottom is steel. I think that aluminum is "ok" as long as your rotors are made of brass or steel. Aluminum rubbing on aluminum will gall up even with oil in there. Aluminum just wears quickly and won't maintain the tolerences needed for very long. Plastic would not be a good choice in my opinion.