Well.
The progress for the last few months has been slow with the build, but still some.
Did managed to draw and print fenders for the rear and a simple bumper.
Last week some tires arrived and of course I had to try them out.
Fit the wheel well but way too wide to use on the rear axle.
And with so many small parts everywhere and always ending on the floor I ended up on making a better storage system.
So much more space on the worktable now, and easily expandable, which will happen.
I did make an error regarding the rear axle/boogie system where the inner tires would not fit anymore.
So now I'm at a standstill, do I redesign it all over again or do I upgrade it to a 6x4 model?
Even though that means ordering more parts I'm leaning more towards 6x4 since it be more capable offroad...