View Single Post
  #5  
Old 08-22-2014, 11:48 AM
Rvjimd's Avatar
Rvjimd Rvjimd is offline
Craftsman
 
Join Date: Dec 2012
Location: Des Moines, Iowa
Posts: 884
Rvjimd is on a distinguished road
Default Re: 1/16 Oliver Dozer Conversion

Here are two pictures of the current frame mod to accept the hitec 225MG servos. The angle parts are attached to the casting on the sides and the small brackets capture the servos. Working on a new set of brackets to go up to the 645MG servos. At this point the frame width is too narrow, not sure how I'm going to get the full sized servos in there?





Jim
Reply With Quote