Thread: He is at it again! 1:50 Dozer Conversion
View Single Post
  #78  
Old 09-27-2013, 05:33 PM
Rvjimd's Avatar
Rvjimd Rvjimd is offline
Craftsman
  
Join Date: Dec 2012
Location: Des Moines, Iowa
Posts: 884
Rvjimd is on a distinguished road
Default Re: He is at it again! 1:50 Dozer Conversion
I'm not totally sure about the time but I estimate 4 or 5 hours. The nubs cast on the inner part poked into the hole of the outer tread in front of it. They were never that tight to start with.

Jim
Reply With Quote