Quote:
Originally Posted by gismow
Below the srew hole near the fender you have a rounded corner. This should be the endpoint of the fender. Just draw a straight line from this edge to the fender so that the line touches the fender. This will be the final line. If you want to make it absolute perfect, you must move the complete fender 5mm up. At the T404 the highest point of the fender is placed a bit higher than the lower end of the doors.
|
Thank you for explaining what you meant Gismow. I knew it was never going to be absolutely perfect and was never meant to be but you offer great advice and I appreciate it a lot. If I do decide to make the fenders scale I will definitely look back on what you have to offer. Cheers mate