Help with motor controller...
I used one of these 2x5 RC controllers in my crane and had trouble figuring out how to use the bec. I finally gave up and used a separate battery for the RX and servos, while using the 2x5 for the drive motors. I clipped the red wires from each RX connector on the 2x5. I had all sorts of space so the extra battery wasn't a problem.
The dozer is a different story, not so much extra room under the hood, what with the giant horsepower I got in there now!
So, is this just supposed to plug into the RX and provide power to the RX thru one or both of the motor control wires?
They don't really describe too well how it is supposed to work. I don't remember exactly what it was doing on the crane, but I got tired of messing with it and gave up.
I am waiting on a reply from dimension...
Jim