3d printed lowboy conversion version 2 detachable gooseneck

[bigdogrod]

ok, tried some other files. thanks to EFICKER again on thingverse, this is the same as version 1 except for larger pieces where they attach to the flatbed, and removable gooseneck. i modified this one's gooseneck to be in 4 parts like the 1st trailer as my print bed is not big enough. i also modified the rear bed piece to have a slot so the wood slats could sit recessed a bit. on to the pics.. don't mind the bent wood, still need to trim them down, most of the pieces are at 80% fill, probably 50 hours of printing time.



time to load er up




hmmm we might need a bigger boat.. lol



loaded up and truckin







hey look, we found a friend







here's the 2 side by side version 2's neck is a bit longer which is good, i might modify the angle as the front is a bit close to the ground