|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#1
10-30-2016, 09:09 PM
|
||||
|
||||
RC4WD Pump question
Hi I purchased the pump sold by rc4wd, they apparently use them in the excavator sold by them, my problem is the output shaft on these pumps sticks out 3/16", I know some of you use these, how do you overcome the short length of output shaft? I am going to use belt pulley reduction. I tried turning a small extension, but with so little to hook to it is hard to keep any wobble out of it.
Thanks Terry 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode