|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#1
10-18-2018, 01:07 AM
|
||||
|
||||
Polishing Inside of Hydraulic Cylinder
Working on my Payhauler dump cylinders and have not found any references on polishing the inside of cylinder tube. What grit should I use and does anyone have suggestions/helpful hints for performing this operation? Using seamless stainless for inner three stages and thick-wall brass for the outer can. These are single-acting, so the rod outer surface is not as critical.
Thanks, in advance. Ken
__________________
Big iron is awesome! 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode