|
General Discussion A place to post off topic discussions. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Robbe, Linde H50 fork lift truck
Here are a few pictures of my 1/16th Robbe, Linde H50 fork lift
The pallets are handmade and are based on the measurements I took at work of a CHEP blue pallet The truck did not come with the beacon I ran the wires down the R/H rear support and the red blends in to make the black one look like a cable in flexible conduit The rotating beacon is hard wired into the on/off switch which is next to the driver’s seat to make it look like one of the control levers I need to get a driver figure for the truck Last edited by Brel; 10-20-2017 at 04:51 AM. Reason: replacing pictures due to photbuckets new policy |
Currently Active Users Viewing This Thread: 6 (0 members and 6 guests) | |
Thread Tools | |
Display Modes | |
|
|