![]() |
|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
I made a test piece out of laminated styrene to replace the stock link that curls the bucket. I know it looks horrible, hopefully my final one is out of aluminium and will look a lot better.
![]() ![]() ![]() Ok, the stock distance from hole to hole is 62.9mm. The new one is longer and the distance from hole to hole is 66.5mm. This is the stock link. ![]() Here is the modified link, camera wasn't moved. I didn't check the focus that's why its blurry and looks like the camera was moved. ![]() Modified link again. Bucket curl maxed out, hitting the arms. ![]() Stock link at a little less than maximum lift. ![]() Modified link. ![]() I forgot to take this picture with the modified link installed, but to get this range of motion I took out the glued on spacer around the curl piston rod that limits how much the piston can extend. ![]() Here's a picture of the spacer. It is 15.1mm long. ![]() Tracking says I should get the Orings on Monday, so hopefully I will have a video by then to show the new range of motion and/or any catastrophic failure ![]()
__________________
Youtube username iamaman27 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|