ScaleART - Assembling a MAN TGX/XL 6x6 tractor & Trailer

[Rakthi]

Got the frame ready to drill / enlarge holes for attaching the servo holder for the 2 rear axles.

For this needed to remove the rear fender, rear wheel and exhaust.



Holes drilled / enlarged



Made a simple bracket/clamp to hold servo.



Installed the servo. (Didn't remove the unneeded attachment point at this moment)



Servo holder bolted to the frame. Might elongate the holes a couple of mm so I can move it a bit more towards the fender.



Also could do with some washers near to the exhaust to bring it more in line. Is a tad off.