Another Bruder Mack conversion - RC Truck and Construction

		RC Truck and Construction > RC Truck's Kings of the Road > Highway Trucks and Trailers
Another Bruder Mack conversion

Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks.

Thread Tools

Display Modes

08-03-2012, 08:12 PM

RCP57

Big Dawg On The Bone

Join Date: Mar 2011

Location: Vancouver Island

Posts: 3,677

Re: Another Bruder Mack conversion

I finally had another look at the Mack today. I picked up a $15 360 servo a couple days back for the screw drive on the box. It is a little slow...OK it's quite slow but it does work fairly well. If I get too bored waiting for it to go up and down I think I'll pick up a drill bit for it but for now it's good enough. Now I just have figure out how to drive the wheels and it will be done

.

Reg

Attached Images

	IMG_1162.jpg (53.6 KB, 231 views)
	IMG_1163.jpg (59.4 KB, 289 views)
	IMG_1164.jpg (61.9 KB, 275 views)

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 06:59 PM.