|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#5
07-01-2013, 05:29 PM
|
|||
|
|||
Re: Trying to make a gear pump
Yeah, maybe press fit is the only way, I just like that the cylinder pin is surface hardened and probably more smooth and straight than I can make with my lathe.
The gear on the picture is 11SMnPb30 / C45 steel and the pin is some surface hardened steel (so hard you cannot machine is with HSS). Brazing could be an option if a suitable filler for steel could be found, I've never tried it or seen it done. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode