|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
|
|
Thread Tools | Display Modes |
|
#11
09-05-2013, 03:32 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
Jim, your 1/16 conversion runs nice. Nice job.
On my cable excavator i had to "sharpen" the cups between each tooth so that basically just about a knife blades width actually touches the tracks so that dirt doesn't bind it up.
__________________
Scott "No load is too Small" 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode