|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
|
|
Thread Tools | Display Modes |
|
#10
09-06-2013, 12:31 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
Jack,
No, everything is micro servo. The blade lift servo just pokes out the right side where a standard one leg servo horn is attached to the blade frame with a short piece of wire. I'll get some more detail pics eventually, once I get it all refined and work out some bugs. I'm putting on two new pinnion gears this morning, the first ones I made too thin and they would not stay aligned good enough. Got a second pair and made them a bit taller. Jim 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode