|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
|
Thread Tools | Display Modes |
|
#1
05-24-2014, 05:16 PM
|
||||
|
||||
Drilling custom frame
What is the best way to drill the holes on the tops and bottom of the frame for the cab base etc. I guess I should say to get them centered. The hole on the sides I used stock rails as template guide . Some of my holes on the top aren't quite centered and make everything out of alignment a little
__________________
Thanks for looking. All comments, suggestions, and constructive criticism are appreciated. Dave 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode