|
Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
Quote:
I used two 18 tooth pinion gears (5mm bore) http://cgi.ebay.com/Traxxas-Tra5644-...efaultDomain_0 and one 22 tooth pinion gear http://cgi.ebay.com/Traxxas-E-Maxx-2...ts_Accessories The size of the center gear will not change the ratio as long as the 2 outside gears are the same. So, you could run a 28t 32p gear for the idler gear and that would lower the final output shaft a little. 28t 32pitch 5mm bore gear: http://cgi.ebay.com/CASTLE-CREATIONS...ts_Accessories
__________________
Scott "No load is too Small" |
#2
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
Quote:
IHSteve
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#3
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
Steve, When I said "would lower the final output shaft a little." I meant lower the height of the output shaft not the ratio.
__________________
Scott "No load is too Small" |
#4
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
Quote:
IHSteve
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#5
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
You are welcome Bob but, I wouldn't recommend doing this conversion unless you have the time and tools because an axial trans or an f-350 trans would be a lot easier.
It probably took me 6 or 7 hours to make this but, every time a drive it I will be rewarded that I made it myself. It should sound really cool when it is done because there 8 gears driving against each other from the motor shaft to the final output shaft and there are 2 sets of those gears in metal cases, the hpi GRU and the GRU I made. No offense taken Steve!
__________________
Scott "No load is too Small" |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|