|
Big Boys of the road 4x4/6x6/8x8/10x10 Trucks This forum is for those multiple axle trucks and other vehicles on and off road. |
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
No sir, off the shelf steel drive axles... the drive train are all metal...
|
#22
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
|
#23
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
Coupla random thoughts. One, what axles are you using, if you don't mind me asking? I've used Integy stuff, which isn't bad, if you don't mind dealing with their rather minimalist idea of customer service =)), or random crap off Aliexpress. I'm always looking for something better/different.
As for the dozer, another though is to use an Arduino (ESP8266, ESP32, whatever) for motor control. Have it read in the throttle and steer from your TX and then proportion to ESC's accordingly. My Flysky's iBus output is basically serial, which plays real nice with the microcontrollers, but there are libraries to read servo outputs into the Arduino/whatever if you'd rather go that route. Also leads to all kinds of other clever stuff; I use Arduinos to control the SK/WS2812-style "Neopixel" LED's, and if you're into sound boards or whatever other accessories, the sky's the limit as you can build your own ... well, anything. I have a half-track I'm doing that way, because the front (wheels) motor has to spin at a wildly different speed than the rear (tracks). Could use a servo multiplier and two ESC's, but a small Arduino and a tiny dual-channel motor controller do the trick. Anyway, food for though.
__________________
I mean, how hard can it be? |
#24
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
Quote:
Last edited by Orange RC Works; 01-20-2023 at 04:46 PM. |
#25
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
Sweet, thanks!
-- A
__________________
I mean, how hard can it be? |
#26
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
weather was good for a test run...
https://youtu.be/QeR1s1s7IT8 https://youtu.be/J6JwVCD_qdU https://youtu.be/quz8EwNizB8 |
#27
|
|||
|
|||
Re: 1/10 Oshkosh M1070 A0 (3D Printed/Scratchbuilt)
Finally installed my DIY reverse alarm module and smoke module on this rig.
https://youtu.be/T8ACkqeaQ3o?si=sfqpeAy80Ed045OW |
Currently Active Users Viewing This Thread: 6 (0 members and 6 guests) | |
Thread Tools | |
Display Modes | |
|
|