Peterbilt 6x6 Medium Hauler

[Tommy R]

Originally Posted by frizzen

Would it work to put some mold release (dish soap) on the hubcap, and rtv a stick to it? Once cured use that silicone cup to remove/install.

Or if you have a die that size, run the cap through a couple times to loosen the fit?

Not sure I'm following you... The cap threads on/off easily, but to keep it from unscrewing when driving it'll need to be screwed on fairly tightly, which is a challenge. That makes it difficult to get it off, as well.

My thought was that if I drill through the cap (top to bottom, for example) I could insert a thin allen key in there to tighten/loosen it and the hole might not be too visible.