|
|
|||||||
| Construction News New kits & accessories offered in the world wide marketplace |
|
|
Thread Tools | Display Modes |
|
#1
01-25-2019, 08:42 AM
|
||||
|
||||
Tipper half pipe
Need advice from brainiacs on the forum. I got a heavy metal tipper and the mechanism I put together is struggling with the initial beginning of the upward stroke. Forget about load, it can hardly lift itself. I'm using 3d drive screw that has big aluminum coil, that is stretches under load and about to snap. The motor ratio is 30:1. What can I do?
[IMG]  Untitled by Jack Reichman, on Flickr[/IMG]
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode