[Markus K.]

Thank you, Ed. No problem with any suggestion or different fabrication methods, this could bring some new ideas for following stuff. So they are very welcome! But in this case I want to do it scale and the cylinder can be opened by removing the (again selfmade) hex-bolts M3 from the head.

This pictures shows the rod at the piston end. It has a diameter of 16mm and received a M10 thread and a groove for the gasket. The piston was finished directly mounted on the rod for 100% center fit. After all I think the loctite on the thread should be enough to seal the rod and piston, but the o-ring can't be bad, either.
The bottom parts of the cylinder were silver soldered, because there wasn't a area big enough for soft soldering. To avoid desoldering of the cylinderheads i put them upside down in a small bucket of water.