Quote:
Originally Posted by Espeefan
Great video. Seems like you found a winner there. Amp draw seems very reasonable!
|
Thanks!
Quote:
Originally Posted by Lil Giants
Well done Scott. 
My 922 is the only one I ever put a guage on & I set the press to 15bar (210psi).
The older two hoes, the press could have been higher, I had an amp meter wired in thru the plug... cyls moving - 1.1, no movement - 2.1amp.
Your due dillengence has paid off & benifited all of us. Thank you. |
You are welcome Joe. The info you gave me on the rpm to shoot for is what made me try the rc4wd 80T so, thank you too.
Quote:
Originally Posted by rcguyfarms
that motor seems to be working better then I experienced with mine. I wounder if my pump is out of wack.
|
You might not have been feeding the voltage and load that the motor operates at the most efficiently. I started out by feeding the motor 7.2 volts and when the cylinder speed wasn't fast enough I kept raising the voltage in small amounts until I found the most speed, least pressure & least current draw... The sweet spot for this motor, pump & fluid was around 8.3 volts, .5 amps and about 190psi.