|
|
|
|
#1
03-30-2014, 01:03 AM
|
||||
|
||||
Re: Hauling Dirt out of my basement (present day)
Getting close to run status... got the 4 esc's to talk equally to each other.
  Shortened up the wires & soldered.  Had to a little bit of dremel & hand filing to get the front axle to fit.   The electric steering in place.  Just got to fit the hydraulic system & start tuning the tx.  It was a toasty warm day today here of +9, so I did a little hauling out in the late afternoon... I'm standing in my livingroom to take the pic... I walked up & down the stairs about twenty times in an hour or so... a good bit of excersie.  
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
03-30-2014, 11:02 AM
|
||||
|
||||
|
Re: Hauling Dirt out of my basement (present day)
How wide are those axles from flange to flange ? Does the brushless motor reduce length on the whole gearmotor ? I'm thinking going that route on the pans to gain much needed space on the pans . I'm really impressed the way the 4 gearmotors work on my compactor .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
 |
| Currently Active Users Viewing This Thread: 14 (0 members and 14 guests) | |
|
|
Hybrid Mode
