|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Re: Bruder Delta tracked loader
Quote:
Quote:
Quote:
Since I had to order more parts, I have a more accurate list: Radio system Tamiya twin motor gearbox shims for tamiya gearbox assembly (you loose about 10 to 20% of gear contact on some of them if you leave them sloppy) silicone to seal gearbox up (makes it last a very long time) 2 x slotcar motors (tamiya motors are 3.5 volts and fry quickly) Aluminum stock to make drive hubs 4-40 screws & washers to secure gearbox to chassis Saber tooth motor controller 5 volt 5 amp (continuous) bec Hitec Digital HS-7955 TG lift servo 2 x hitec hs-5065mg digital servos for bucket curl Hitec servo programmer 3" Y harness to join the 2 bucket curl servos 2 x 12" male servo leads to extend the bucket curl servos heat shrink for all of the bucket curl servo wiring piece of bicycle inner tube for lift lever cover (need to post pics) 4-40 rod and clevis for lift lever lead weight and 1 boat load of patience
__________________
Scott "No load is too Small" |
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
|
|