MorePower Hydraulic

[rc_farmer]

Success!, I think i have figured out the hydraulics. Here is a quick video of the setup. I would highly advise that anyone who has the Morpower block to pressures test all the fittins and replace all the 3mm set screws before installing in your machine. I have replaced 5 of them that was leaking with 3mm caphead screws.....no more leaks.

[RCP57]

You're not running their pump though? RC4WD pump in that video?

[rc_farmer]

That is a Morpower valve block. I bought that pump as an extra when i bought the setup. The original pump is a 540type brushed. I am going to replumb everything once in the excav. I am also going to use a different type tank.

Also, those servos are junk. The kill the rcv'r if more than two are plugged in, Steve said to use Hitec 85mg which i will p/u on monday.

[RCP57]

Originally Posted by rc_farmer

That is a Morpower valve block. I bought that pump as an extra when i bought the setup. The original pump is a 540type brushed. I am going to replumb everything once in the excav. I am also going to use a different type tank.

Also, those servos are junk. The kill the rcv'r if more than two are plugged in, Steve said to use Hitec 85mg which i will p/u on monday.

I was just wondering if you used the RC4WD style pump because you didn't like the Morepower one or???? I almost ordered a pump from them a while back but chickened out. Just wondering what your thoughts were on it compared to the RC4WD pump? I would like to buy a pump for my log skidder and it needs a fair amount of volume.